VGA/Stereo Audio Matrix Switcher 8x8
PTN Electronics Limited www.PTN-electronics.com
10
Status.
Inquire the input channel to the output channels
one by one.
Save[Y].
Save the present operation to the preset command
[Y]. [Y] ranges from 0 to 9.
Recall[Y].
Recall the preset command [Y].
Clear[Y].
Clear the preset command [Y].
Note:
1. [x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged
according to the model of the matrix switcher. If the symbols exceed the effective
range, it would be taken as a wrong command.
2. In above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3. Please remember to end the commands with the ending symbols “.” and “;”.
4. Type the command carefully, it is case-sensitive.
Detail Examples:
1
、
Transfer signals from an input channel to all output channels: [x1]All.
Example:
“3All.” to transfer signals from the input channel No.3 to all output channels.
2
、
Transfer all input signals to the corresponding output channels respectively:
All#.
Then the status of it will be: 1->1, 2->2, 3->3, 4->4
…, 8->8.
3
、
Switch off all the output channels: All$.
Then there will be no signals on all the output channels.
4
、
Check the version of the firmware:
/^Version;
To check the version of the firmware.
5
、
Switch off the detail feedback command from the COM port: /:MessageOff;
I
t will leave the “switch OK” as the feedback, when you switch the matrix.
6
、
Switch on the detail feedback command from the COM port: /:MessageOn;
It will show the detail switch information when send the commands.
7
、
Transfer signals from an input channel to the corresponding output channel:
[x]#.
Example:
“4#.” to transfer signals from the input channel No.4 to the output channel
No.4.
8
、
Switch off an output channel: [x]$.
Example:
“4$.” to switch off the output channel No.4.
9
、
Switch both video and audio signals synchronously: [x1] B[x2].
Example:
“2B2,3,4.” to transfer signal from the input channel No.2 to the output
channel No.2,3,4.
10
、
Inquire the input channel to the output channel [x]: Status[x].
