6. Make certain the emitter points are straight and paral-
lel to the plane of the fan.
7. Replace the front grill.
Bracket Removal
The IN5110 blower can be removed from the univer-
sal bracket by unscrewing the side knobs. Note that
there are washers located between the side knobs, stand
and chassis.
Service
Ptec™ ionizers are reliable products with a long ser-
vice life. If you feel your unit is not operating properly,
turn off the unit and disconnect the power cord. Contact
Transforming Technologies’ Technical Support for repair
assistance.
Troubleshooting
The information below provides a reference for prob-
lems that may arise with your IN5110 benchtop blower. If
you have other problems not covered below, please con-
tact Transforming Technologies’ Technical Support for
repair assistance
Problem
Causes
Balance outside
Emitter points are dirty, damaged
specifications.
or not straight. Clean or replace
Alarm light activated
Low HV output, call for repair
Unit is arcing, call for repair
Short circuit, call for repair
6
