16
Flash triggering methods
You can trigger your flash using the:
• Remote trigger—See “Using the remote trigger” on page 16.
• Light sensor—See “Using the built-in light sensor” on page 17.
• PC sync cable—See “Using a PC sync cable to trigger your flash” on page 18.
Using the remote trigger
To use the remote trigger:
1
Plug the PC sync cable on the remote receiver into the SYNC jack on your flash, then plug the receiver’s power
connector into the AC power socket on your flash.
2
Plug the power cable into a power outlet.
3
If another device interferes with the signal between the receiver and transmitter, change to a different channel
by sliding the switches on both the receiver and transmitter to the same channel.
Note:
The receiver and transmitter come preset to the same channel.
The remote trigger has 16 channels.
Note
If
OF
appears on the display, the flash triggering feature is
turned off. The modeling lamp will light, but the flash will
not trigger.
PC sync cable