Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 62 / 348

Chapter 2:Assembly And Basic Operation
Operation Of The Integrated Scanner
36
Teklogix 7035, 8255 & 8260 Terminals User Manual
Important: If an aiming dot is available on the installed scanner, the dot will
be enabled for a configurable time period, after which normal
scanning begins. Refer to “Dot Time” on page 134 for details.
Double-clicking the trigger will override the aiming delay and
initiate an immediate scan. Note that the aiming dot is standard
on long-range and high visibility internal scanners.
• Aim at the bar code and press the scan key or the trigger. A scan beam and a
warning indicator appear until a successful decode is achieved or two
seconds have elapsed. For terminals using external scanners, the warning
message can be turned off by setting the “Scan Indic” parameter to “N”.
Refer to “Scan Indic – 7035 Only” on page 134 for details.
Note: 7035 terminals with internal scanners always display this warning
indicator, even if the “Scan Indic” parameter is set to “N”.
Figure 2.6 7035 Scanner Warning Indication
Successful Decode
If the scanner has successfully read the bar code:
• The terminal beeps.
• The warning indicator disappears.
Troubleshooting
If the scanner is not working, investigate the following:
• Is the terminal on?
• Check that the bar code symbology being scanned is enabled for the
terminal you are using. Check any other parameters that affect the scanning
procedure or the bar code.