Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 160 / 348

Chapter 7:Setting Parameters
Other Options
134
Teklogix 7035, 8255 & 8260 Terminals User Manual
Click Data
For both integrated and external scanners, this parameter determines which
character is sent to TESS or ANSI following a double-click. Enter the ASCII
value of the character desired from 0 to 255. You can also press the <LEFT> and
<RIGHT> arrow keys to scroll through a set of ASCII characters not available from
the keyboard.
Scan Result – 7035 Only
When this parameter is enabled (set to “Y”), the type of bar code and the result of
the scan appear on the terminal screen. Note that this information is only displayed
after a successful decode and only as long as the scanner trigger is pressed. When
the trigger is released, this information is cleared from the screen.
Scan Indic – 7035 Only
When this parameter is enabled (set to “Y”), the laser warning logo appears on the
display whenever the scanner is activated. For the Teklogix 7035-I integrated
terminal, this message is mandatory and appears even if this parameter is disabled
(set to “N”).
Dot Time – 7035 Only
Important: “Dot Time” only appears in the Scanner Options menu when
either “Long Range” or “High Vis” is selected as the internal
scanner option. Internal scanner options are described on
page 130 under the heading “Internal”.
The value selected for “Dot Time” determines how long the targeting dot remains on
before the scanner switches to a normal scan sweep. The allowable values are:
0, 0.1, 0.5, 1.0, 1.5, 2.0, 2.5
and
3.0
seconds.
Result Time
The value assigned to the “Result Time” parameter determines how long the scan
results of a successful scan are displayed on the terminal screen. Time is measured
in seconds, and a value of “0” (zero) disables the parameter.
Note: To remove the scan result from the screen before the “Result Time” has
expired, perform an unsuccessful scan.