Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 61 / 348

Teklogix 7035, 8255 & 8260 Terminals User Manual
35
Chapter 2:Assembly And Basic Operation
Panning The Display Contents
2.9.2 Panning The Display Contents
7035, 8255 and 8260 terminals support autopanning as a default mode. The screen
will pan as necessary to ensure the current cursor position is always visible.
Note: Refer to “Auto Pan, Left Margin, Right Margin And Bottom Margin” on
page 124 for a instructions about setting parameters for autopanning.
The terminals also support manual panning. Refer to “Manual Panning Keys
(Arrow Keys)” on page 49 for a description of manual panning.
2.10 The Integrated Scanner Option – 7035 Only
2.10.1 Warnings
For your own safety, it is critical that you comply with the following warnings:
1. Do not look into the laser beam.
2. CAUTION – Using controls or adjustments, or performing
procedures other than those specified herein may result in
hazardous radiation exposure.
3. CAUTION – The use of optical instruments with this product
will increase eye hazard.
4. This product contains a laser scanner that emits less than 1.0 mW
average radiant power at a wavelength of 650 or 680 nm. This
product complies with 21 CFR 1040.10, 1040.11 and DIN EN
60825: July 1993, and is classified as a Class 2 laser product.
2.10.2 Operation Of The Integrated Scanner
• Turn the terminal on.Wait until the unit has booted to Tekterm or a
DOS prompt.
• Test the scanner by pointing it at a light coloured surface and pressing the
scan key or the pistol grip trigger. The scanning beam should be energized
and the warning indicator (shown in Figure 2.6) should be displayed on the
terminal screen.