Chapter 6: Peripheral Devices & Accessories
Snap Modules
178
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
•
Model No. ST4005 (USB DE9M variant): through a powered DE9M serial connector it
powers and charges the hand-held, and provides communications to tethered devices.
The DE9M connector is capable of speeds up to 115,200 kbp.
Figure 6.5 Snap Module Models and Installation
To attach the adaptor to Omnii:
•
Make sure that the adaptor connector and Omnii docking connector are free of dust or
any other debris before connecting them.
•
A slot in the side rail on each side of the hand-held accommodates the locking clips of
the adaptor. To attach the adaptor, align it with the base of the hand-held and gently slide
up until the locking clips snap into place (Refer to Figure 6.5).
•
To remove the adaptor, press down on the base of the clip arms to release them from the
Omnii side rails and slide the adaptor off.
ST3101 (Charger)
ST4001 (USB Host/Client)
ST4005 (USB DE9M)
DC IN Port
Locking Clip
Side Rail
Hand Strap Slot
Note: If you are using a hand or shoulder strap, there is no need to remove it before
installing the Snap Module, since the Omnii hand strap slot will still be accessible.
