Chapter 6: Peripheral Devices & Accessories
Pistol Grips
172
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Table 6.3 Pistol Grip Model Numbers
The pistol grip is attached to the back of Omnii using the four threaded inserts in the upper
part of the Omnii casing (see Figure 6.1). Four M3x6 Phillips head screws are provided.
•
Position the pistol grip so that it fits snugly over the back of the unit and the holes in the
pistol grip are aligned with the threaded inserts on the back of the hand-held.
•
Using a Phillips screwdriver, tighten the screws to a torque of 3 lbs-in (3kgf-cm) to
secure the pistol grip in place.
Figure 6.1 Attaching the Pistol Grip
Pistol Grip Description
Model Number
Standard Pod
ST6000
Integrated
ST6100
Accessory Auto Range
ST6400
Note: Prior to installation, make sure the trigger mechanism is securely snapped into the
pistol grip body and that the trigger operates properly.
