Chapter 5: Configuration
Ports Tab
158
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Enabled
This parameter must be set to ON in order for Omnii to recognize the device connected to
the Port Replicator 9-pin (COM5).
Baud
Double-tapping on this parameter displays a pop-up window in which you can choose an ap-
propriate rate of data transfer.
Figure 5.6 Port Baud Rates
Data Bits
This parameter determines the number of data bits included in each asynchronous data byte.
Most devices use 8-bit data bytes. Double-tapping on this option displays a pop-up window
in which you can choose either 7 or 8 data bits.
Parity
This parameter determines the type of parity checking used on the data going through the
port replicator port. Double-tapping on this option displays a pop-up window in which you
can choose the appropriate parity.
Stop Bits
This parameter specifies the number of stop bits—1, 1.5 or 2—used for asynchronous
communication.
