Psion Teklogix OMNii HDK XT10, User Manual

Page: 89 / 192

Chapter 5: Mechanical Considerations
End-Cap
Psion Teklogix Omnii HDK User Manual 79
2. Remove the four Torx screws securing the end-cap to the main housing.
3. Gently pull the end-cap away from the main housing.
To attach the new pod module:
1. Route the cable for the end-cap module through the opening in the top of the unit, and connect
to the appropriate socket on the main unit.
2. Fit the new end-cap module into place on the main housing, being careful not to catch the
cable in the seal.
3. Install four M3x5 T10 Torx screws to secure the end-cap to the main housing. Torque the
screws to 5.0 in-lb (0.56 N-m).
4. Replace the back cover.
a. Attach any back cover cables to the appropriate sockets on the main logic board.
b. Seat the back cover in place on the main housing.
c. Install eight M3x6 T10 Torx screws to secure the back cover to the main housing. Torque
the screws to 5.0 in-lb (0.56 N-m) in the sequence indicated below to ensure a consistent
seal around the perimeter.
d. Install two M2x8 Torx screws in the two mounting points at the top of the display on the
front of the unit. Torque the screws to 2.5 in-lb (0.28 N-m).
1
2
3
4
8
6
7
5