PSI PlantPen/N-Pen N 110, Instruction Manual

Page: 30 / 33

Page | 30
11 GPS
MODULE
The new version of the N-Pen 110 device has integrated GPS module which can be turned on during the measurements. When GPS
module is turned on the map coordinates will be automatically saved with all collected data and will be downloaded during data
download.
For proper GPS reading, the time in your N-Pen and in your computer must be synchronized. Preset time and time
zone must correspond to GPS time (time zone) in your location.
11.1 GPS/N-P
EN OPERATION
1. Check the time setting on the N-Pen device: Settings > Date & Time
2. Switch the GPS module “ON” on the N-Pen device by following these steps in the menu:
•
Select: Accessories > GPS
•
Press SET to confirm.
•
Wait until the GPS position is found – “ Starting GPS ”.
•
The GPS module is ready when the icon in upper panel changes as shown on Fig. 25.
3. If the picture on the display of the device does not change then proceed to
Accessories>GPS>Location selection in the menu and manually map the GPS by pressing SET. “ GPS Acquisition “ message will appear
followed by coordinate. If the GPS module has diffi culties mapping the coordinates, a message stating “ GPS not locked ” will appear
on the display. It may be necessary to take the device outside into a location that is easily accessible by the satellite (clear sky view)
and repeat the process of mapping.
4. Once the GPS has been turned on and successfully activated proceed to Measurement and select required protocol.
For prompt determination of the coordinates use the option Accessories > GPS > Location.
The device may need a clear view of the sky to acquire satellite signal.
Keep in mind that the N-Pen turns off automatically after about 8 minutes of no action.
Turning off the N-Pen always turns off GPS module.
Fig. 25 GPS icons.