Required Accessories:
• 7mm Pen Mandrel
• Drill Bit: PKEXEC-38
• Bushing Set(2 pc): PKSPRTBU
• Barrel Trimming set: PKTRIM38 or
• Squaring Jig with 3/8” sleeve from PKTRIMSET
• Live Tailstock or Mandrel Saver
• 2 part Epoxy or Thick CA (Cyanoacrylate) Glue
• Pen Blank Minimum Size: 3/4” x 2-1/2”
#PKSPRTXX
PSI Woodworking Products
Mobile Device Support Kit
Preparing the Blank:
• Cut 1 blank to the to the length of the tube, adding 1/16” for squaring off.
• Drill 3/8” hole lengthwise through the blank.
• Spread glue over the tube, insert the tube into the blank with a twisting motion to spread the glue evenly inside.
• Center the tube lengthwise inside the blank.
• When the glue is dry, square the ends of the blanks, making sure the trimmed ends are 90º to the tube. Use a 3/8”
barrel trimmer, or a pen blank squaring jig with a 3/8” sleeve on a disc sander. Take the excess material down fl ush to
the ends of the tubes. Do not trim past the end of the tube since this may interfere with the operation of the
mechanism and assembly. Use a barrel trimmer to clean the inside of the tube.
Kit Features:
• Dual purpose stylus and mobile device stand with hands free viewing
• Device can be mounted horizontally or vertically
• Easy to Turn With Straight Tube
• Minimal Parts--easy to assemble
• Available in multiple fi nishes
• Overall Length: 3-7/16”
• Replacement stylus tips available
DIAGRAM A / PARTS LAYOUT
*Do not press directly on Stylus Holder or Device Holder. See Diagram C
1.384”
Sliding Clamp
Stylus Holder*
Device Holder*
Tube/Barrel
Stylus Tip
Coupler
Top
Side
In Use
