10
Mini PowerWedge
®
Predefined Defaults
The Mini PowerWedge has the following sets of default parameters:
T
Pred
e
fined Default 0 (D0)
turns every on/off parameter off and
sets all minimum and maximum lengths to zero (00). This default
set makes it easy for you to start with everything off and then
enable only the bar code symbologies and parameters you wish
to use. This can prevent unwanted data entry to your applica-
tions.
T
Predefined Default 1 (D1)
turns every on/off parameter on and
sets all maximum lengths as high as possible. It also sets bar code
and magnetic stripe preambles and postambles. This default set
gives you the best chance of reading an unknown bar code sym-
bology, and it also identifies the bar code type for you.
T
Predefined Default 2 (D2)
is the default set that was installed in
the decoder at the factory. This default set meets most users’
needs.
You can reset your Mini PowerWedge to one of the predefined
default sets by scanning one of the following bar codes:
NOTE
The host device setting (C0) is not affected by the
predefined default sets.
T
D0
*$+$-D0EE*
T
D1
*$+$-D1EE*
T
D2
*$+$-D2EE*
