PSB CustomSound CW180R Quick Start Manual Download Page 2

11.125"

283mm

4"

102mm

9.875"

251mm

• 

Platinum-derived 8” woofer and 1” t weeter

• 

Unique high-frequency, constant directivity SonicGuide™ 
gimbals to provide a focused, even response both on and off 
axis 

• 

SonicGuide™ can be tilted 30° left or right and the whole 
assembly turned through 90 degrees

• 

Fully enclosed back box NCB available

• 

Midrange and t weeter switches allow for response 
adjustments

Frequency Range (-6dB):  

38-21,000Hz

Recommended Power:      

20-100 Watts

Impedance:                       

4 Ohms

Sensitivity (1W (2.83V) @1m) 
  

Anechoic Chamber: 

88dB SPL

  

Typical Listening Room: 

90dB SPL

Drivers:                            

8” Woofer

 

 

1” Dome Tweeter 

Overall Dimensions (W x D):  

11 1/8 diameter x 4” 

Cut-out Dimensions (W):  

9 7/8” diameter

Overall Dimensions (W x H x D):  

11 1/8 x 11 1/8 x 4” 

Cut-out Dimensions (W x H):  

9 7/8 x 9 7/8”

CW180R / CW180S 8” Coaxial Speaker System

w w w. p s b s p e a k e r s . c o m

1   8 8 8   7 7 2   0 0 0 0

PSB Speakers reserves the right to change specifications or features without notice. 

© 2004 PSB Speakers, a division of Lenbrook Industries Limited. 

PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 09/04. All rights reserved. 

No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers.

•  Try to install the systems at a height 

bet ween seated and standing ear level.

•  Distance bet ween left and right speakers 

should approximately equal the distance from 
the listening area to the wall or ceiling.

•  Make small exploratory hole and check for 

obstructions in wall cavity before cutting 
mounting hole.

•  Use template provided and carefully mark and 

cut mounting hole.

•  Lightly fi ll wall cavity with fi berglass for 2 

feet above and below system (CW180S).  Use 
standard 4” fi berglass split to half thickness.  
Use 1” thick fi berglass behind system.

•  Adjust electric screwdrivers to appropriate 

torque.  Tighten 4 mounting screws fi rmly but 
do not over tighten!

•  SonicGuide t weeter can be - 45 

degrees via the gimbal ring, then +- 30 
degrees on its axis.

•  Aim t weeter toward center of listening area.
•  Switches give subtle balance adjustments 

for midrange and treble.  Set to suit room 
acoustics and listener taste.

•  See manual for more installation hints.

Installation Notes

11.125"

283mm

4"

102mm

9.875"

251mm

Reviews: