4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
Quick Start Guide 3
®
Quick Start Guide
Owner’s Reference
UPC Power Center
©2004 PS Audio International Inc. All rights reserved.
If the AC power source is a balanced transformer or Power Plant, plug the UPC-200 into the output
of the transformer or Power Plant.
Once the UPC-200 has been connected to the power source, make sure that power source is
energized and providing AC power to the UPC-200.
If you are using an AC wall receptacle to power the UPC-200, make sure the AC receptacle is not a
switched outlet. Switched outlets are those outlets that can be turned on/off with the wall switch. It
is advisable to leave the UPC 200 powered at all times.
Once the UPC-200 has been powered, plug your AV equipment into one of the two the AC receptacles
on the UPC-200. Make sure to use a high quality aftermarket AC power cable to power your equipment
from the UPC-200. It is important to note that the AC power cable is a critical link in the chain and
great care should be taken to ensure only the best non-restrictive AC power cable is used to power
both the UPC 200 and your AV equipment.
Turn your equipment back on. Make sure everything is powered up properly with the UPC-200
between the AC receptacle and your AV equipment.
At this point you should be ready to enjoy the benefi ts of clean safe power provided by the UPC-
200.
Avoid switched
outlets
Connect your
equipment
Connect the
power
