®
Operation Guide
Owner’s Reference
PerfectWave Power Plant 10
(<+06
7:
Operation
Guide
4826
Sterling
Drive,
Boulder,
CO
80301
15-056-01-1
PH: 720.406.8946 [email protected] www.psaudio.com
Rev D
©2010 PS Audio Inc. All rights reserved.
6.
ALWAYS ON: In this setting, the P10 will output power from this zone regardless of
whether the front-panel power button is engaged. As long as the Power Plant 10 is
plugged in and the back-panel power switch is flipped, any zone set to ALWAYS ON will
output regulated, regenerated AC power.
Note
that pressing the Next button will take you from control parameters for Zone A to the
parameters for Zone B, C, and D respectively. All Zone setting can be made with the same
instructions and suggestions as described above for Zone A.
SineWave & MultiWave
By selecting the icon labeled WAVEFORM the Power Plant 10 will toggle between MultiWave or
SineWave. In the MultiWave position, the peak charging time of the sine wave is extended to help
connected equipment lower power supply ripple and will therefore improve the performance.
MultiWave can have the same improvement gained from adding a larger power transformer or more
power supply capacitance to connected equipment.
Degaussing Connected
Transformers
By selecting the icon labeled CLEAN
the Power Plant 10 will activate the
CleanWave function and the display
of the P10 will begin to countdown
the time left as the P10 is applying
the CleanWave signal. CleanWave
places a series of higher frequencies
that ride on the main sine wave to help
“degauss” connected magnetics. To
ensure that CleanWave is effective,
make sure all connected equipment is on and functioning. CleanWave can be used between CD’s,
movies and vinyl. It is not recommended to activate CleanWave while you are listening as it may not
sound correct until the CleanWave cycle has finished. The option exists for a 10 second or a 60
CleanWave cycle by touching the Add Time button.
12
WAVEFORM
CLEANWAVE
