6
(701) 566-0452
6-Post Rack Assembly Instructions
1. With someone holding the middle frame, attach the 42” and 18” crossmembers to the
bottom of the frame. When attaching the crossmembers, be sure to orient them correctly
(see Min. and Max. in Figures 3 & 4). The crossmembers need to be assembled this way for
future accessories to fit properly.
2. Attach 42” and 18” crossmembers to the top of the frame (Figures 3 & 4).
3. Next, attach the front and rear uprights to the newly installed crossmembers (Figures 3 & 4).
4. Attach angle foot (Figure 4).
5. Once both uprights are attached, place the spreader plate at the bottom rear of the rack.
6. Secure all the hardware but do not fully tighten. Repeat steps 1-5 on the other side of
the rack.
6
1. Next have someone hold the frame you just assembled, while you attach the 42” and 18” crossmembers
to the bottom of the frame as shown below. The rack will now be able to support itself upright making it
easier to attach the top crossmembers.
2. Next, attach the front upright and the rear upright to the crossmembers you just installed. The front angle
feet should also be attached at this time as shown in Figure 5.
3. Once both uprights are attached, place the spreader plate at the bottom rear of the rack, and make sure
it stays flat to the floor when bolting in place.
4. Next repeat steps 1-3 for placing the crossmembers and uprights on the other side of the rack.
5. Snug all the hardware but leave loose enough so the pullup bar can be assembled in later step.
[email protected] 701-566-0452
6-Post Rack Assembly
6
Figure 6
7
7
10
2
3
Figure 4
Min.
Max.
7
4
9
8
1
10
Figure 5
Max.
Min.
Figure 3
Figure 4
Figure 5