INCLINEO handbook
20
The number of readings to be taken then saved is set using
or
. After setting
number of readings required, press
ENTER
. The duration for each measurement is then
prompted as shown below.
Set the duration for each measurement using or . Press
ENTER
to confirm setting the
duration. The following screen appears.
Press [HOLD] to start taking and saving set measurements.
If a storage location has previously been used, it is important to note the number
of measurements previously saved in the location, as new measurents are
recorded successively. This is important when viewing saved measurements. In
the preceeding example, the next measurement will appear as number 017.
The taken and saved measurements may be displayed using the memory submenu item
“view” which is accessed as described at the beginning of this section (Memory).
Press
ENTER
with “view” displayed. The selection of the data storage location is prompted.
Use to select the location where measurements to be viewed have been saved.
The bottom right corner of the display shows the
currently selected storage location [04] and number of
measurements presently stored in the location [000].
This display shows the current storage location [05] and
number of measurements already stored in the location
[016].
If a storage location has previously been used, it is important to note the number
of measurements previously saved in the location, as new measurents are
recorded successively. This is important when viewing saved measurements. In
the preceeding example, the next measurement will appear as number 017.
!
Note
