5
ACID WASH FOR REMOVAL OF CALCIUM DEPOSITS ON CELL PLATES
WARNING: FOR QUALIFIED POOL PROFESSIONALS ONLY
DO NOT ATTEMPT THIS PROCEDURE WITHOUT PROPER TRAINING
CAUTION: USE PROTECTIVE EYE WEAR, GLOVES, AND PROTECTIVE CLOTHING
1. Turn PUMP OFF and allow water to drain back out of the cell and by-pass system.
2. Disconnect the ¼”
BRAIDED HOSE
from the Venturi Injector.
3. Place a bottle of Muriatic acid close to the Venturi Injector
4. Attach one end of the two (2) foot ¼ inch BRAIDED HOSE provided to the open port on the Injector, secure with clamp. Put the other end
of the hose in to the container of Muriatic acid.
5. Turn the pump back on for approximately 1 minute or until Salt Cell is filled with acid.
6. Turn the pump off for 15 to 20 minutes to allow the solution to soak the plates.
7. Repeat Steps 5 and 6 above until the calcium build-up is gone.
NOTE: The solution entering the pool will not disturb the pH of the pool’s water.
NOTE: If build-up is not removed, contact your local dealer or Prozone for additional advice.
8. Reconnect VENTURI to system.
9. Turn PUMP ON.
WINTERIZATION
Freezing water may damage the Cell’s internal components and may cause cracks in the casing , voiding the Warranty. If severe, or extended
periods of freezing temperatures are possible, drain all the water from the pump, filter, Salt Cell, supply and return lines before freezing occurs.
SPRING START-UP
Balance your pool and perform start-up as listed in this manual.
