16
Push a blind captive nut
(27.4)
into the hole in the lower moulding.
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
Install a washer
(27.3)
on the lower strap anchor
(27.2)
and screw into the captive nut
(27.4)
. Ensure that the hole in the strap anchor is oriented so that the karabiner
(27.1)
can
be attached
On the underside of the tripod bowl
(19)
, remove and discard the screw
(27.5)
securing the
corresponding leg clamp
(19.2)
. Do not remove the washer
(19.1)
.
Position the bowl strap anchor
(27.6)
on the leg clamp, ensuring it is correctly oriented. Us-
ing Loctite 221, secure the bowl strap anchor with the 25 mm M6 screw
(27.5)
supplied with
the strap. Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners
(27.1)
, clip the strap
(27)
to the strap anchors and adjust to length.
'Spread-Loc' mid-level spreader
The ‘Spread-Loc’ mid-level spreader
(28)
is available as an optional accessory. To install the
spreader:
Grip the ends of each spreader arm in turn between thumb and fore-finger and press in the
attachment release buttons
(28.1)
.
Push the arm into the tripod attachment
(25)
until the release engages.
Fit the carpet feet
(29)
.
To remove the spreader, press in the attachment release buttons
(28.1)
and free each arm
in turn.
'Spread-Loc' mid-level spreader
(29)
(25)
(28)
(28.1)
