Proton ICS-1290, Manual

Page: 38 / 115

39
Add a Data Format
Step 1. Scan the Enter Data Format barcode
.
Step 2. Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3
alternate formats. This allows you to save a total of 4 differentdata
formats. To program your primary format, scan 0 using the
Programming Chart inside the back cover of this manual. If you are
programming an alternate format, scan 1 , 2 , or 3 , depending on
which alternate format you are programming.
Step 3. Terminal Type
Refer to Terminal ID Table and locate the Terminal ID number for your
PC. Scan three numeric barcodes on the inside back cover to program
the scanner for your terminal ID (you must enter 3 digits). For example,
scan
1 2 4
for an PC Keyboard.
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
In the Symbology Charts, find the symbology to which you want to
apply the data format. Locate the Hex value for that symbology and
scan the 2 digit hex value from the Programming Chart inside the back
cover of this manual.
Step 5. Length
Specify what length (up to 9999 characters) of data will beacceptable
for this symbology. Scan the four digit data length from the
Programming Chart inside the back cover of this manual. (Note: 50
characters is entered as 0050. 9999 is a universal number, indicating
all lengths.)
Step 6. Editor Commands
Refer to Data Format Editor Commands . Scan the symbols that
represent the command you want to enter.
Step 7. Scan Save to save your data format, or Discard to exit withoutsaving
your changes.
Step 8. Scan the selected data format "Data Format 1 " barcode forthe
configuration to take effect.