Proton ICS-1290, Manual

Page: 43 / 115

44
Data Format Editor Commands
Send Commands
Send all characters
F1
Command format=F1xx(xx: hexadecimal of the character to be
inserted)
Outputs all characters to the right of the cursor and then outputsthe
character xx.
Refer to the ASCII Conversion Chart for decimal, hex and character
codes.
Send a number of characters
F2 Command format=F2nnxx(nn:00-99, the length of the character to be
sent; xx: the hexadecimal value of the character to be inserted)
Outputs nn characters to the right of the cursor and then outputs the
character xx.
Refer to the ASCII Conversion Chart for decimal, hex and character
codes.
Send all characters before the last few characters
E9 Command format = E9nn (nn: 00-99, the length of the lastcharacter
not output)
Outputs all characters from the right side of the cursor to the front of
the last nn characters (left side). The cursor moves to the right of the
last transmitted character (that is, to the left of the last nn characters).
Refer to the ASCII Conversion Chart for decimal, hex and character codes.
Insert a character multiple times
F4 Command format=F4xxnn(xx: hexadecimal value of the character to
be inserted; nn:00-99, times of characters output)
The character xx is output nn times, and the cursor position is
unchanged.
Refer to the ASCII Conversion Chart for decimal, hex and character codes.
Data format configuration
Scan the " Data Format Off " barcode. The barcode data is output accordingto
the data content without adding data format, but includes the prefix and suffix.
(8860010.)
Data Formatter Off
.