START-UP PROCEDURE
NOTE:
1. If after 30 seconds, it has not recognized the helicopter, turn off the
controller and repeat Start-Up procedure.
Before flying, the helicopter and transmitter must be turned on in sequence and
synchronized.
1. Turn on the helicopter. The front light will begin to flash.
2. Place the helicopter on the ground facing away from you.
3. Turn on the remote control.
4. Push the throttle up and then down. The light on the remote will turn steady
to indicate it has synced.
5. Your helicopter is now synchronized, and in stand-by mode awaiting Engine
Idle command.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the helicopter, press the engine on button to go into idle mode.
Alternatively, you can push the throttle up and release to go into idle mode.
The blades will rotate but the helicopter will not lift.
6
ENGINE ON BUTTON
