Locking pin
"i"
Workin rope
Connector
Automatic brake
inside the cover
STOP
EXTEND
THE ROPE FROM
REEL WHEN THE
RED SIGN
APPEARS!
MAX
500 kg
Additional anchor point
for additional equipment
installation.
WORKING ROPE INSTALLATION
Remove locking pin from the top side of the pulley.
1.
Insert end of the rope with connector between pulley wheel and arm on the opposite side of the winch - step "i".
2.
Secure rope installed on the wheel with locking pin.
3.
CAUTION!
The lifting / lowering function is for lifting / lowering loads only. Do not use AT 252 anchor beam witch winch for a
•
rescue or a fall arrest purposes.
Always operate the winch with hand power and with crank included in the equipment only.
•
Before each use a thorough inspection must be carried out. Inspection must be carried out by a person using the
•
device. In the case of damages and malfunctions, the device should be withdrawn from use.
Nevel allow to full extension of the working rope from the winch reel. Keep at least three rope coils on the reel - it is
•
marked by a special safety sign which situated on the rope. Stop extend the rope from the reel when the safety sign
appears! Obligatory check the condition of the safety sign.
DEVICE LOAD CARRYING CAPACITY
The load hoisted by the AT 252 anchor beam may be connected to the end of the working rope and/or to the additional
attachment point.
Maximum operating load carrying capacity of the device is 500 kg.
5/7
