The relay will only switch if:
With window contact only:
Window open
With window and stove contact:
Stove off
Stove on and window open
With window and roller shutter and stove contact:
Stove off
Stove on, window and roller shutter open
Factory settings on the central unit
Press the reset/learn button and hold it down for 10 s
in order to delete all the learned transmitters. The reset
routine is shown with a single beep as an acoustic signal
and functions correctly if all the LEDs are flashing green.
If only the power LED is flashing green then the table
definitely needs to be deleted, which is initiated by
keeping the reset button depressed again. The central
unit will respond with 2 acoustic signals, a pause and
another 2 acoustic signals and the power LED will be
reset to being lit constantly.
Release the reset button again after these signals. The
sensor table and the corresponding flash memory in
the device have now been deleted. This is shown by
the constant lighting of the power LED. None of the
corresponding sensor LEDs should be lit.
Encoding
The following steps are necessary to teach the
relevant sensors:
Pairing can now be initiated by briefly pressing the
reset/learn button. This is shown by a short acoustic
signal and all the LEDs flashing green. If the procedure
has not been interrupted after 7 seconds then learning
can begin. (However if this happens then only press the
button once the routine is back in default condition).
The transmitters are now paired individually.
The set button on each sensor is activated and this is
answered by the sensor by flashing red-green.
(The same LED signal is also displayed when the
SET routing is running)
After approx. 10 seconds the LEDs on the central
unit display which sensor type was taught and one or
several acoustic signals will sound again in accordance
with the number of sensors that have already
been taught.
Caution:
A logical AND association of the sensors is
created if one sensor is fitted with the AND jumper
and the following must be an OR Sensor. Completing
the pairing process with an AND or a subsequent stove
sensor will produce an ERROR (three short, three long,
three short) and returns the central unit to the
factory reset.
EN
35
Summary of Contents for 4260070567025
