2
2.0 SYSTEM REQUIREMENTS
2.1 COMPATIBILITY OF COMPONENTS AND SUBSYSTEMS:
This equipment is designed for use with
PROTECTA approved components and subsystems. The use of non-approved components and subsystems
may jeopardize compatibility of equipment, and could affect the safety and reliability of the complete
system. Contact Capital Safety if you have questions about compatibility of equipment.
WARNING:
Before using a Cabloc Ladder System in combination with a climb assist system, consult
the climb assist system manufacturer’s instructions for any restrictions or limitations concerning
simultaneous use of these systems. Capital Safety has found that some connection combinations may
interfere with proper operation of the Cabloc Detachable Sleeve and may result in failure to arrest a fall.
Avoid connecting the sleeve used on the Cabloc Ladder System into the same harness connection D-ring
as is occupied by the climb assist system. Ensure that movement of the arm of the Cabloc sleeve is not
restricted or interfered with by the climb assist system or its connectors. Failure to heed this warning may
result in serious injury or death.
2.2 COMPATIBILITY OF CONNECTORS:
Connectors used with this system (hooks, carabiners, D-rings) must
be capable of supporting a minimum of 5,000 lbs. Use caution to assure compatibility of hooks and the
connection point. Non-compatible connectors may unintentionally disengage (roll-out). Connectors must be
compatible in size, shape, and strength. All connectors used must be self closing/self locking connectors.
3.0 OPERATION AND USE
3.1 BEFORE EACH USE:
Inspect the ladder climbing system according to the manufacturer’s instructions. Do
not climb a structure that is not in good condition. Verify from the label markings that the system has been
formally inspected within the last year. Do not use a defective or improperly maintained Cabloc system.
Inspect the detachable cable sleeve according to section 5.0. Inspect your full body harness according to the
manufacturer’s instructions.
3.2 CONNECTING THE CABLOC CABLE SLEEVE TO THE CARRIER CABLE:
WARNING:
The Cabloc sleeve must only be used on a vertical cable system. Do not use the cable on
angled or horizontal cable systems as the sleeve may no lock properly on the cable. In situations where a
fall hazard exists, use a back-up fall arrest system, such as a lanyard, to protect against a fall.
Step 1.
Ensure the sleeve is correctly positioned relative to the carrier cable. The “up” arrow on the sleeve
must be pointing to the ascending direction. See Figure 2.
IMPORTANT:
Never install the sleeve upside down on the cable.
Step 2.
Remove the carabiner and pivot the handle to its full upright position. This will draw back the
cable shoe to allow insertion of the carrier cable into the sleeve housing. The sleeve design does
not allow the sleeve to be installed or removed while the carabiner is attached to the handle.
Step 3.
Rotate the top of the sleeve to the right until the sleeve body is horizontal. Position the sleeve
so that the cable slides all the way into the cable installation slot. Rotate the sleeve back into a
vertical position so that the cable is captive in the cable slot.
Step 4.
Allow the handle to return to its operating position. This will allow the cable shoe to contact the
cable and lock the cable in the sleeve body. Reattach the supplied Carabiner to the attachment
point of the Cabloc sleeve.
Figure 2 - Installation
Step 1
Step 2
Step 3
Step 4
