ESD Safe Solder/Desolder Rework Station
TS1648
IMPORTANT SAFETY INFORMATION:
• When using electrical appliances basic safety precautions should always be followed.
• Check that the voltage indicated on the rating plate corresponds with that of the local network before
connecting the appliance to the mains power supply.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
unless they are older than 8 and supervised.
• Do not operate the appliance with a damaged plug or cord, after a malfunction or after being dropped or
damaged in any way.
• If the supply cord is damaged, it must be replaced by a qualified engineer in order to avoid injury or hazard.
• The soldering iron must be placed on its stand when not in use.
• Ensure there is sufficient space and ventilation around the appliance to allow the escape of heat and/or fumes.
• Never place the product or part of it in water, or operate if your hands are wet.
• Wear appropriate clothing and safety goggles while soldering.
• Soldering work must be conducted on a stable, non-combustible surface.
• Do not touch any metallic parts near the soldering tip/nozzle.
• Do not leave the soldering iron unattended while it is switched on.
• Wash your hands thoroughly after working with solder.
• Make sure the power switch is in the “off” position and disconnect the plug when the unit is not in use.
• Before storage, ensure the power is off and allow the station to cool down to room temperature.
1. About Products:
This 2 in 1 SMD hot air rework station is an excellent tool for soldering work.
And it is super high cost-effective.
It is suitable for soldering and desoldering all types of surface mounted IC, PCB or components.
The innovative heater and sensor provides a quick heat-up and rapid temperature recovery.
The hot air pump handle is embedded with sensor.
The unit will immediately enter into Working Mode when you pick up the handle, and will go into Standby Mode
when you put the handle back to the holder.
2. Technical Specifications:
Voltage: 220-240V~50Hz
Soldering iron: 24V, 60W
Hot air pump: 300W
Temperature range: 50-480°C(soldering iron), 100-500°C (hot air pump)
