PROGNOST F
Instructions for use
5041-0-8002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany
12 von 27
NOTE
Every operating elements are described in the corresponding manual.
2.1
General safety notice
2.1.1
Requirements for operation
WARNING!
Protection Class I ME device
To reduce the risk of electric shock, this unit is designated exclusively for
connection to a supply network with protective earth.
In use with an X-ray generator:
The power for the components of the x-ray system table PROGNOST F is
designated to be exclusively supplied through a direct connection to the
available X-Ray generator. The X-Ray generator is required to offer a minimum
of two connection ports with 230V 50/60Hz.
The X-ray system table PROGNOST F is a Class I ME product (according to EN
60601-1). To reduce the risk of electric shock, this unit is designated
exclusively for connection to a supply network with protective earth.
This device contains no on/off switch. The PROGNOST F is directly connected
to the X-Ray generator and is switched on/off through the switching on and
off of the generator itself. In order to disconnect the PROGNOST F from the
power the connected X-Ray generator must be shut off.
2.1.2
Operating of the radiographic system
In case of functional disturbance, e.g. due to electromagnetic interference, the PROGNOST F shall no
longer be used and the customer service department of PROTEC or a service company authorized by
PROTEC should be informed.
2.1.3
Operating personnel
The PROGNOST F should only be operated by personnel who are trained in accordance with the
corresponding national regulations in the use and operation of diagnostic X-Ray systems.
NOTE
Only properly trained and authorized personnel are allowed to work with the
PROGNOST F.
The user, as well as the service personnel, must pay attention to the warnings, notices and safety
instructions located on the device and in the user manual. Failure to comply with the information
provided can lead to injury.
NOTE
Operating personnel are required to acquaint themselves with all warnings
(warning signs) located on the device. They serve to ensure the safety of the
operator as well as others and set a basic for orderly operation.