27
MARK76V3002 Rev 3
Important Notice:
• Never operate this machine when the ambient room air temperature is greater than 90
degrees Fahrenheit. Never operate this machine when it is not ventilating itself properly
(too hot inside).
• This device may not be used by people with reduced physical, sensory or mental
capabilities or who have insufficient epxerience and/or knowledge without supervision. A
person responsible for their safety must make sure, either by supervision or instruction,
tha tthe deivce is used correct and safely. If there is any doubt about the above mentioned
instructions then that person cannot use this device.
• Never operate this machine when it is not ventilating itself properly (too hot inside).
• The salon owner or operator may never, under any circumstances, open the bench or
canopy of tanning units without the supervision of an authorized service person.
CAUTION:
Please refer to your individual unit for the recommended exposure schedule and
proper exposure times for the model that you have purchased.
The Electrical requirements for your ProSun unit are:
Model
Breaker 1 Volt 1
Breaker 3 Volt 3
Hertz Operating
Amps 1
Operating
Amps 3
ProSun V3 42 Xlc 40 Amp 230V ~ N/A
N/A
60 Hz 32 Amp
N/A
Operating any 230 Volt combination at voltage levels below 218 Volts or above 230 Volts
for the ProSun Units constitutes an automatic NULLIFICATION of the manufacturers factory
warranty, because it could cause damage to the unit’s system.
Please insure that your electrician and/or installer, reads this user’s manual carefully prior to
the installation of your ProSun unit. You will need a buck booster if voltage requirements are
not met. Service personnel should be authorized by ProSun to perform work on equipment
and should have knowledge of equipment and read the full manual.
WARNING:
Always disconnect the ProSun unit from its power supply when serving or
repairing the unit.
WARNING:
Mains circuit breaker is used as a means of disconnect. .
WARNING!
