Thank you for purchasing this product, we are sure that it will serve you for many years to come.
To optimise the performance of this product, please read these operating instructions carefully to
familiarise yourself with the basic operations of this unit. Please retain them for future reference.
This product has been tested at the factory before being shipped to you. To prevent or reduce the
risk of electrical shock or fire, do not expose the unit to rain or moisture. To prevent a fire hazard,
do not expose the unit to any naked flame sources. Unplug this apparatus during lightning storms
or if it is unlikely to be used for long periods of time.
When installing the unit, please ensure you leave enough space around the unit for ventilation.
Always handle the power cable by the plug. Never pull out the plug by pulling on the cable. Never
touch the power cable when your hands are wet as this could cause an electric shock. A damaged
power cable can cause a fire or give you an electrical shock. Check the power cord periodicaly, if
you ever find that it is damaged, replace it before using the unit again.
The voltage of the available power supply differs according to country or region. Be sure that the
power supply voltage of the area where this unit is to be used meets the unit’s requirement.
Caution: to prevent the risk of electric shock, do not attempt to open the unit. No user-‐serviceable
parts inside. Refer all servicing to qualified service personnel.
Manufacturer declarations
In compliance with the following requirements: RoHS Directive (2002/95/EU) and WEEE Directive
(2002/96/EU). If this product is ever no longer functional please take it to a recycling plant for
environmentally friendly disposal.
CE declaration of conformity
R&TTE Directive (1999/5/EU), EMC Directive (2004/108/EU), Low Voltage Directive (2006/95/EU).
Installation
The charger is designed for Prosound
N51QR, N52QR and N54QR
rechargable microphones. Do
not attempt to use any other microphones with this charger. Do not use the unit where there are
extremes in temperature (below 41°F / 5°C or exceeding 95°F / 35°C).
Operation
Connect the power adapter to the rear of the charger and then connect
the adapter to the mains power. The power indicator LED (3) will then
light up flashing between red and green three times.
To charge the microphones, simply place the microphones inside the
charger sinks (1). The charger will immediately start to charge the mics.
When the charge indicator LED (2&3) is lit, the corresponding
microphone is being charged. When the mic battery is fully charged,
the charge indicator LED will change from red to green.
If there is a fault with the batteries or they are imcompatible with the
charger, the charge indicator LED will flash red and green. If this
happens, replace the reachargeable batteries in the microphone.
e
w
r
q
q