3170-PDP Installation Guide
2
Mounting Instructions
1. Position the PROFIBUS adapter module (A) on a 35 x 7.5mm DIN rail (B) (A-B pt. no. 199-DR1; 46277-3; EN 50022) at
a slight angle
2. Hook the lip on the rear of the adapter onto the top of the DIN rail, and rotate the adapter module onto the rail.
3. Press the adapter module down onto the DIN rail until flush. Locking tab (C) will snap into position and lock the adapter
module to the DIN rail.
4. If the adapter module does not lock in place, use a screwdriver or similar device to move the locking tab down while
pressing the adapter module flush onto the DIN rail and release the locking tab to lock the adapter module in place. If
necessary, push up on the locking tab to lock.
5. Connect the adapter wiring as shown under Wiring.
NOTE: For Panel/Wall mounting, refer to publication 1794-2.13, Panel Mounting Kit, Cat. No. 1794-NM1.
3170-PDP
3,4H x 2.7W x 2.7D
(87H x 68W x69D)
A
= Mounting hole dimentions fom optional mounting kit
B
= DIN rail
C
= Secure DIN rail approximately every 200mm
Mounting Dimensions
Inches
(Millimeters)
