manualshive.com logo in svg

Pro'sKit N2 Series, Manual, Page: 3 / 4

Share
Download
Pro'sKit N2 Series Manual Download Page 3

Version 1.0                                                                                                                                      Date

：

29/08/2018

 

-

 

3- 

www.raise3d.com

 

Step 3:

 

Shown below are the two adjustable A4988 stepper drivers (Red).

 

 

 
 

Step 4:

 

 

Using  the  multimeter,  touch  the  red  probe  to  the  adjustable  screw  on  the  driver. 
Touch  the black  probe  to  the  lower  screw of  the  second  green terminal  (this  is the 
negative  electrode  of  the  heat  board).  Then  multimeter  should  display  the  current 
voltage of the driver.

 

 

Summary of Contents for N2 Series

Page 1: ...om Manual N2 Series 104 Voltage Adjust of A4988 v1 0 Preparation 1 Unload filament 2 Move the build plate to center height 3 Turn off the power Tools Multimeter 2mm hex wrench Small Philips head screwdriver The one we use here is 2mm in diameter ...

Page 2: ...rsion 1 0 Date 29 08 2018 2 www raise3d com Step 1 Locate the electronic box located at the right side of your printer Step 2 Unscrew the four attachment screws with the 2mm hex wrench to remove the cover ...

Page 3: ...88 stepper drivers Red Step 4 Using the multimeter touch the red probe to the adjustable screw on the driver Touch the black probe to the lower screw of the second green terminal this is the negative electrode of the heat board Then multimeter should display the current voltage of the driver ...

Page 4: ...rewdriver to turn the adjustable screw The voltage will to up when turned clockwise and down when turned counterclockwise Step 6 Make changes slowly and measure the voltage periodically until the measurement reads 0 9V Repeat last two steps until the goal of 0 9V is reached END ...

Reviews:

No comments