2. Connect the wire leads to the wire pair under test.
3. If there is no continuity, the LED will display RED.
For continuity (
＜
500Ohm), the LED will gradually diminish
until there is NO Light.
Testing Continuity - TONE Mode
(
CAUTION :
Do not connect the Tone Generator in the TONE
position to any wire or cable with an active DC circuit exceeding
48V)
1. Switch the Tone Generator to the TONE position. The TONE LED will
display RED.
2. Connect the wire leads to the wire pair under test.
3. Use a headset or handset at the remote end.
4. An audible tone signals continuity.
Battery
1. The Tone Generator has a low battery LED. When the LED
displays RED, replace the battery
2. If the Amplifier Probe volume is low, replace the batter
y.
3. Unscrew screw on battery cover. Remove the battery cover and replace
the batter with a new 9V battery. Reattach the cover. Do not overtighten.
