PT-1201 User’s Manual
www.prokits.com.tw
6
Complied with EN60335-2-29
Indoor operation only
.Accessory
Screwdriver bits
15PCS
Bit size
6PCS drills:
Φ
1.5/ 2.5/ 3/ 4/ 5/ 6 mm
1PC extension: 60mm (L)
6PCS: PH1 ; PH2; PZ1 ; PZ2 ;SL 5 ;SL 6 mm
(L : 25mm)
1PC : SL6-PH2 (L : 45mm)
1PC : SL5-PH1 (L : 45mm)
Product Features
Operation Instructions
Insertion and Removal of Rechargeable Battery
Ensuring the correct orientation between the battery and the battery
compartment, insert the rechargeable battery into the machine. Do not apply
force when inserting the battery. Insertion can be achieved easily and without
Operating trigger
Forward &Reverse switch
Torque adjustment
Battery Charger
Battery Release
Button
PT-1201 User’s Manual
www.prokits.com.tw
7
resistance. The battery must be inserted completely until the battery retention
clips on the sides of the battery compartment automatically lock it into place. To
remove the battery press the battery retention clips and pulls the battery out of
its compartment.
Charging the Battery
The rechargeable battery must be charged before the first use. Only recharge
the battery once it is has been fully discharged, i.e. the performance clearly
decreases. Otherwise the battery may not achieve its full capacity at the
subsequent charge.
Important!
Only use the provided battery charger for charging the battery. First
place the rechargeable battery into the charging slot in the charger and then
connect the charger to the mains. Charging starts automatically.
Remove the battery from the charge after about 5 hours. Always disconnect the
charger from the mains before you remove the battery from the charger.
Inserting Tool Bits
Important! Always remove the battery before you change the drill or screw bit to
avoid unintentional starting of the machine.
The cordless drill has a keyless chuck so you do not need a key to lock the tool
bit in place. Make sure that the drill or screw bit is not skew when it is inserted
and the chuck tightened.
Before inserting drill/screw bits open the jaws of the chuck by holding the lower
ring of the chuck and turn the locking ring anticlockwise. Open the chuck until
you can insert the tool. Insert the drill/screw bit all the way in and then holding
the lower ring, turn the locking ring in a clockwise direction to firmly tighten it.
To remove the tool hold the lower ring of the chuck and turn the locking ring
anticlockwise.
Open the chuck until you can remove the tool
Operating Trigger
Use the operating trigger to start the machine and keep holding it for continuous
operation.
The rotation speed can be varied by depressing the operating trigger. The more
the trigger is depressed, the faster rotation speed.
To switch the machine off, release the operating trigger
Forward and reverse switch
Important! The machine has to come to a complete stop before the reverse
rotation lever can be used; otherwise the machine may be damaged.
Use the forward and reverse switch to switch between clockwise (normal) and
anticlockwise rotation or vice-versa. With the forward and reverse switch in the
central position the operating trigger is locked and cannot be depressed. Put the