Page 11
5.
Important! If you wish to reset the grinding push quickly twice the “SHARP” button
when the skate-holder is going from left to right. When the skate-holder is moving
from right to left only one push is needed for “reset”. Never start the machine
without a skate unless you are dressing the grinding wheel!
6. Check the result and the skate is finished. For more detailed instructions how to
use the electronics and adjustments please take a look at the control panel
manual. (Page 4)
7. Notice! Figure skate application has to be ordered separately.
Change of the grinding wheel
Changing of the wheel and all service work may only be done when the
main power is switched off. But before switching the power off please read
these instructions.
Drive the skate-holder to the left
by using the arrows at “SPEED” .
Now switch the power off.
1. Adjust the wheel towards you by turning
the “blade-thickness” nut 5 full rounds
clockwise. See Picture 1. Now the nut is getting more accessible.
2. Loosen the grinding wheels nut and remove the grinding wheel.
3. Put in a new wheel so that the text label is towards you and tighten it moderately.
4. Adjust the wheel sideways 5 full rounds anti-clockwise to 3.0 mm.
5.
Now
switch on the power.
After changing the grinding wheel you have to
reset the wheel size counter by pressing both arrows down for 3
seconds.
You will hear
“beeps” from the machine and the resetting is done. Now
you can drive the skate-holder back to the starting position by using the arrows
and at the same time keeping the wheel-arm down by hand. See Picture 8.
6. Dress the wheel with desired hollow. See instructions for Dressing of the grinding
wheel. Page 9.
7. For more detailed instructions how to use the electronics and adjustments please
take a look at the control panel manual (Page 4.)
Picture 8.
.
Picture 1.
