XXX℃
TEMP XXX℃
XXX℃
SET XXX℃ TOOL
2) Feeding length: rotate the knob, when "LEN" is displayed in the second column
_
on the left, press the knob to set the feeding length, the adjustment range is
_
0 ~ 99.5mm, and press the knob to save the setting;
3)
Return length: rotate the knob, when "RET" is displayed in the second column
_
on the left, press the knob to set the return length, the adjustment range is
_
0 ~ 19.5mm, and press the knob to save the setting;
4) Interval time: rotate the knob, and when the "INR" is displayed in the second
_
column on the left, press the knob to set the interval time, the adjustment range
_
is 0 ~ 9.5s, and press the knob to save the setting;
5) Feeding speed: rotate the knob, when the "SPD" is displayed in the second
_
on the left, press the knob to set the output speed, with the adjustment range
_
of 1 ~ 40mm / s, and press the knob to save the setting;
6)
Working mode: rotate the knob. When the "MODE" is displayed in the second
_
column on the left, press the knob to enter the working mode. The adjustment
_
range is 0 ~ 9. Press the knob to save the setting;
•
"0" is the manual working mode. The feeding time is manually controlled by
the foot switch or by the handle button.
•
"1-9" is the automatic working mode. Just press the foot switch or handle
button to automatically complete the feeding according to the set length. When
the number is "1", it completes one automatic control cycle, and when the
number is set to "2", it completes two control cycles. The pause between cycles
is determined by setting the "interval time" parameter.
•
set "1" and the feeding length is set "0", once working it will continues till the
foot switch or handle button press again to stop.
•
The temperature set less than 200℃, the soldering iron will be closed , solder
wire feeding function can be use seperatly.
---℃
TEMP ---℃ 米 ━
5.4.3
Password setting:
Long press the knob and turn it to "PASSWORD". Press the knob to enter the pass-
word setting. only when “1 PWD” and “2 PWD” are the same number you can save
the setting parameters and exit after "LOCKED!" displayed. If the number input are
different, "FAIL!" will displayed.
PASSWORD
CALIB
PASSWORD 1PWD xxx
2PWD xxx
The LCD display show a symbol of “ ”under the Password Setting Mode, you can’t
set parameters and there will be “ENTER THE PWD!” required, enter the Password
setting and input the password to unlock, the symbol of “ ” disappeared and then
you can set parameters
。
When “1PWD” input "0" and “2PWD” input "0", press the knob can clear the pass-
word set before. once you forget password, you can input number "166" to unlock
.
8
