PT-1805 User’s Manual
www.prokits.com.tw
7
Important!
Only use the provided battery charger for charging the battery.
FUEL GAUGE BATTERY PACKS
Battery packs include a fuel gauge which consists of four red LED lights to
indicate the level of charge remaining in the battery pack.
To actuate the fuel gauge, press th
e “POWER” button, the four LED will light up
to indicate the level of charge left. When the level of charge in the battery is
below the usable limit, the fuel gauge will not light up and the battery will need to
be recharged.
Temperature Dependent Overload Protection
When using as intended for, the tool cannot be overloaded. In case of
excessive loading or when exceeding the allowable battery temperature range
of 0
– 50°C, the speed is reduced or the tool switches off. In case of reduced
speed, the tool will not run at full speed until after reaching the allowable battery
temperature again. In case of automatic shut-off, switch the tool off, allow the
battery to cool down and then switch the tool on again.
Inserting Saw Blade
Important!
Always remove the battery before you change the saw blade to
avoid unintentional starting of the tool.
The cordless jig saw has a keyless chuck so you do not need a key to lock the
tool bit in place. Make sure that the saw blade is not askew when it is inserted
and the chuck tightened.
1. Turn the saw blade lock to the side.
2. Push the saw blade into the slot in the chuck.
3. Release the saw blade lock to lock the blade.
NOTE
: The teeth on the saw blade must face in the direction of the sawing.
4. To remove the saw blade
– turn the saw blade lock to the side and take out
the blade.
Important! Danger!
Check the tight seating of the saw blade. A loose saw blade can fall out and
lead to injuries.
On/Off Switch
To start the tool, press on the lock-off button first to activate it, and then press
and hold the On/Off switch.