P9
將電池盒取出
打開上蓋取出鎂合金片
以滴管吸取鹽水點在不織布上，請勿沾濕極性位置
上蓋
水
鹽
使用前請耐心閱讀以下注意事項
a.
b.
c.
如何將鹽水添加到玩具車
鎂合金片
鹽水製作
:
請取出容器裝水，以鹽
1:5
水的比例調製，基本上鹽的比例從
20%~99%
都可以驅動玩具車，但以鹽佔
20%
的效果最好。
1
2
極性位置
How to make salt water solution: Add salt to tap water or distilled water at ratio of
1(salt) : 5(water)
. Any
percentage ratio from 20% to 99% salt water is workable although the 20% will be the most efficient.
Water
How to fill the Baja Runner with salt water
Cover
Magnesium
Sheet
不織布
Nonwoven
Fabric
Remove cover and
magnesium sheet
Add salt water on nonwoven fabric
Remove FC module
Polarity
position
鹽 水 電 池 製 作
How It Works
Please pay full attention to the below mentioned before use!
6
6
鹽水能量大約20分鐘後就會耗盡，同時速度會變慢並停止。此時請再依照附圖
位置增加鹽水即可
每個鎂合金片約可持續使用3小時，當鎂合金片氧化至不堪使用時請更換新鎂合金片。本產品隨貨附
贈2片鎂合金片備品
本產品是對環境安全、無毒、乾淨的鹽水燃料電池玩具，無須擔心丟棄會造成環境危害。
The salt water will be exhausted after a period time ( about 20 minutes). The Baja Runner will begin
to get slower or stop. Add few more salt water drops to start it again (as below fig. ).
Each Magnesium sheet can work for 3 hours continuously, then becomes fragmented. Replace the
sheet with a new one to energize the Baja Runner. The kit includes 3 refills.
All materials used in this kit are environmentally safe and clean, no toxic substances or disposal
concerns.
P10
將鎂合金片及上蓋蓋回
將電池組插回原位
開始狂奔囉~~
d.
e.
f.
黑色空氣極
黑色空氣極
4
每次使用後收藏前，請在自來水下輕輕地清洗黑色空氣極，請勿搓揉表面以維護品質。
3
將電池組取出即停止狂奔
Reassemble cover and
magnesium sheet
Insert FC module
Run the Baja Runner now
Remove FC module to stop the Baja Runner as shown below:
It is necessary to clean FC module every time when not in use, gently rinse air cathode
under tap water, don’t hand rub the surface to ensure the quality of air cathode.
Air Cathode
Air Cathode
