PP 1500
Quick Start Guide
Operation Guide - Turning Off LCD Display
1. Press the
SELECT BUTTON
to toggle between two lighting modes. In the default mode, the
LCD DISPLAY
is turned
on and the light around the
POWER BUTTON
is at full brightness. In the second mode, the
LCD DISPLAY
is turned off
and the light around the
POWER BUTTON
is dimmed.
Operation Guide - Changing Output Waveform
1. There are two different output waveform modes:
Sine-wave
(default) and
Modulated-wave
.
2. While the unit is regenerating output power, press and hold the
SELECT BUTTON
until
LCD DISPLAY
shows:
3. To switch to Modulated-wave output, press and hold the
SELECT BUTTON
until
LCD DISPLAY
shows:
4. The above steps will toggle between
Sine-wave
and
Modulated-wave
output modes.
Regenerating...
sinewave
Regenerating...
Regenerating...
sinewave
Regenerating...
Modulated-wave
Operation Guide - Setting the Output Voltage
1. You can set the output voltage only when the unit is in standby mode (refer to section “Powering ON”).
2. Press and hold the
SELECT BUTTON
for more than 2 seconds, then release. Repeat until
LCD DISPLAY
shows:
3. Short press the
SELECT BUTTON
to set the output voltage between several preset voltages.
Output Voltage
230 V
