3
4
DO NOT FLY YOUR X18 IN FOUL WEATHER!
WARNING
CONTROLLER DIAGRAM
Power Indicator Light
Throttle Stick
!UTO3TART,AND"UTTON
&ORWARD"ACKWARD4RIM
Direction Stick
0OWER/N/FF
,EFT2IGHT
Turn Trim
,EFT2IGHT"ANK4RIM
Speed Button
360
˚
Stunt Roll Button
#(-ODE#(-ODE
Back of Remote-Controller
X18 DIAGRAM
FLIGHT PREPARATION
s6ERIFYTHATTHEREAREh!!vBATTERIESINSIDETHEREMOTECONTROLUNITANDTHE8HASBEEN
fully charged.
s-AKESURETOBEINALARGEOPENSPACEPREFERABLYAFIELDORAPARKWITHANOPENRADIUSOFATLEASTFEET
s-AKESURETOSTARTYOURDRONEONACLEANFLATLEVELSURFACEBEFORETAKEOFF
s
IMPORTANT! Until you have experience in flying your X18, it is not advised to use in any rate of wind.
Pick a day with zero wind day or extremely light wind condition when learning how to fly.
SYNCING YOUR X18
Important! When syncing your X18 with the controller always make sure that the drone is on a flat
level surface and that your digital trim settings are in the center position. This insures that the 6 Axis
gyro is properly programmed to respond to your trim settings.
Your X18 utilizes an automatic 2.4G
channel selection system that allows up to 8 people to fly side by side in the same wireless range with no
interference.
1. Before starting, make sure that the power switch on your controller is off and the battery is removed
from the X18. Make sure that there are no other 2.4G devices in the area.
2. Insert the battery into the X18 and set it down on a flat level surface. The red and green LED lights on the
drone should begin to flash rapidly.
3. Quickly turn ON the remote and you will notice that the top red LED light on the face of the controller
should also be flashing.
4. Push the throttle stick all the way up until it stops and then pull it back all the way down to the
bottom(see diagram below). When pushing the stick up or pulling the stick down you should hear a
high-pitched beep both ways and the indicating lights on the drone and contoller will stop flash and stay
solid on. You have successfully synced your X18 and are ready to fly. If this doesn’t happen repeat steps 1-4
again.
s
TIP 1: Try not to leave too much time between putting your battery into the drone
and turning on the controller or your syncing window will time-out.
s4)03YNCINGYOURDRONEINDOORSORINTHESHADEWILLMAKEITEASIERTOSEETHE
LED light indicators on both the controller and the drone.
Move the control stick all the way
up and all the way down, you
should hear two beeps.
The flashing red LED light will
become solid when you are synced.
1 2 3
4CH
3CH
Speed Indicator
Rotor Blades
Front(Green Light)
Back (Red LED Light)
Landing Gear
Battery
Compartment
Digital Camera