2. DC Current Measurement A (DCA):
2.1 Connect the RED test lead to “VΩmA” jack when the
current is less than 200mA and to “2A” jack when the
current is larger than 200mA.
Connect the BLACK test lead to the “COM” jack.
2.2 Set the FUNCTION switch to the desired DCA position.
2.3 Connect the test leads across the source or load under
measurement.
3. AC Voltage Measurement V
(ACV):
3.1 Connect the RED test lead to “VΩmA”
jack and BLACK test lead to the “COM” jack.
3.2 Set the FUNCTION switch to the desired ACV position.
3.3 Connect the test leads across the source or load under
measurement.
4. Resistance Measurement(Ω):
4.1 Connect the RED test lead to “VΩmA” jack and BLACK
test lead to “COM” jack.
4.2 Set the FUNCTION switch to the “Ω” position.
4.3 Connect the test leads across the resistor under
measurement.
4.4 When measuring the resistance, the power should be
turned off and in short circuit status by connecting the
two test leads.
VII. OPERATING INSTRUCTION:
1. DC Voltage Measurement V (DCV):
1.1 Connect RED test lead to “VΩmA” jack.
BLACK test lead to “COM” jack.
1.2 Set the FUNCTION switch to the desired V
(DCV)
position. If not sure, set to the highest range.
1.3 Connect the test leads across the source or load under
measurement.
ENG
ENG
4. Resistance:
RANGE
RESOLUTION
ACCURACY
200Ω
0.1Ω
±2% of rdg±10digit
2000Ω
1Ω
20KΩ
10Ω
200KΩ
100Ω
2000KΩ
1kΩ
Overload protection : 250VDC or AC ms. Less than 2 sec.
Maximum open circuit voltage : 2.8V
5.
Diode and Continuity:
Diode : Testing voltage approx.2.4V,current 1.5mA, indicate
forward diode approx. value
EL1410.indd 8-9
06-07-12 17.10.57
