pronovost P-920, Operator'S & Parts Manual, Page: 11 / 44

- 11 -
ASSEMBLY
ASSEMBLY
1) The Snowblower is shipped partly assembled.
2) Install 3-point system according to the model of
your Snowblower. (See section 10 for parts
numbers). Use the holes most convenient to the
type of tractor used (Fig. 16).
3) Install P.T.O. shaft with the shear pin end onto the
Snowblower gear box (Fig. 17). Then attach
safety shield support chain as shown (Fig. 18).
WARNING: The telescoping tubes of the drive
shaft must never be allowed to bottom out while
maintaining a minimum overlap of 6 inches.
4) If you install a hydraulic cylinder on the chute
deflector, use model 25TR08 cylinder.
5) When installing chute, grease the groove of the
UHMW slide in order to prevent the corrosion of
the rim of the chute.
6) Install the chute rotation mechanism.
Figure 16
Figure 17
Figure 18
4