________________________________________________________________________________
5
–
Squeeze&Turn 19472-19479
2
Assembly
When mounting the attachment, protective shoes should be worn, as the parts can cause injury if
dropped.
2.1
Disassembly and scrapping
When scrapping the attachment and control box should be sent to a recycling center or Pronomic
to guarantee recycling and safe handling of all the consisting parts of the tool.
3
Use
It is important for you to read and understand this manual before you begin using your
attachment.
3.1
Rotate
The rotate function is controlled from the control box. To activate this function simply move the
joystick to the left or to the right.
3.2
Grip and lift
The gripping arms should always be positioned in the center of the load (gravity center). Position
the tool using the trolley maneuvering control for up/down and the joystick for rotate. Be sure the
tool will grip the load in a proper way.
Press and hold the squeeze button until it stops and the load is gripped. Make sure the arms have
gripped the load properly and then procced lifting the load.
If the squeeze tool is equipped with one moving arm and one fixed arm position the fixed arm
underneath the roll when loading horizontally. Use the same position when transporting the roll
on the trolley.
3.3
Moving the load
Before moving the load to another location rotate it so that the load is resting on the arms. This is
to prevent the load from slipping out of the gripper due to vibrations. Always lower the tool and
load to the lowest position possible before moving.
