4
3.
A cable is provided from the transmitter rear panel that can be
connected to
the audio outputs (Left and Right) present on a TV set, Hi-Fi system, VCR or
radio-cassette player, or to a headphones/earphones output using the connector
supplied.
The red Auto On indicator light will light up as soon as you have connected the
power adapter to the mains outlet and the audio cable to a signal source. If the Auto
On indicator light remains off, switch on the audio source and increase its output
level until the red indicator light comes on.
RECEIVER HEADPHONES
1.
Open the cover of the battery compartment located on the right hand receiver
headphone.
2.
Insert two rechargeable LR03/AAA size batteries taking care to ensure
correct polarity.
3.
Close the battery compartment cover.
OPERATION
1.
Switch on the sound source (TV set or audio component) that the transmitter
is connected to.
2.
Place the headphones On/Off switch in the On position.
3.
Place the headphones on your head and adjust the volume to obtain the
desired sound level.
4.
If you cannot find the best reception frequency, press the "Auto Scan" button
on the headphones. The corresponding indicator light will come on.
5
NOTE:
You should then be able to move around freely from one room to another without
any interference. If interference does occur (interruptions in the signal), press the
"Auto Scan" button once to find a better reception channel.
A
For better stereo reception, stay approximately seven meters away from the
transmitter when you press the "Auto Scan" button.
B
If it is impossible to find a satisfactory frequency, change the setting on your
transmitter, then press the "Auto Scan" button on the headphones to find the
corresponding channel.
To both protect the transmitter and save power, the transmitter automatically
switches off after approximately one minute if the signal that it receives from the
audio source is too weak for proper reception. If however the signal returns to an
acceptable level, then the transmitter automatically switches back on.
CHARGING THE BATTERIES
1. Place the On/Off switch on the receiver headphones in the Off position.
2. To recharge the headphone batteries, place the headphones on the transmitter,
taking care to ensure that the charge contacts touch the transmitter's charge
prongs.
3. The charge process starts automatically and the green indicator light comes on.
Be sure to charge new batteries for 24 hours before using them for the first
time in the headphones.
