LIZARD
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
15
3.7. Operating
After setting the power switch to the
position ‘I’, the carriage will turn on. If the
carriage is to control the torch, set the arc ignition switch to the position
‘I’.
With
state
shown
on
the
main
menu
(Fig.
6)
the
current
program
can be changed by simultaneously pressing and rotating the knob F2. Use the speed
adjustment knob to change the current welding speed. Right rotation increases the
speed by
the
step
of
0.1,
and
left rotation decreases the speed by the same step.
Use the travel direction switch to select a direction of motion. The carriage will
start
moving
according
to the chosen
program
parameters.
The indication of the current
operating mode will show on the display during program execution. The carriage
speed can be adjusted during operation using the speed adjustment knob; however,
the new speed will not be saved if the current program changes in the meantime.
The carriage stops after reaching the total length and
confirmation
message shows on the display. Then, set the travel direction switch to the position
‘O’ to go into the main menu.
After
the
work
is
finished,
turn
off
the
power
using
the
power
switch
and unplug the carriage from the power source.
CAUTION
! If the arc ignition switch is set to position ‘I’, the torch
will start welding immediately after selecting a travel direction.
