Promolife H2, Manual, Page: 3 / 4

H2 HYDROGEN INHALATION SYSTEM 6 H2 HYDROGEN INHALATION SYSTEM 3
SAFETY - READ BEFORE USE
• Place the machine upright on a level surface.
• Do not turn on the machine without water inside.
• Do not place the machine in direct sunlight.
• Drain the unit every 7-15 days.
• Do not use volatile chemical solvents to clean the machine.
• Do not use a power supply rated for less or more than the
power requirements of the unit.
• When the unit will not be used for some time, drain
remaining water and unplug it.
• When used with other electrical appliances, the devices
should be more than 30cm apart to avoid interference.
TROUBLESHOOTING
General Notes: If there is abnormal noise, smells or smoke, cut off the power
immediately and stop using the machine.
No hydrogen production/gas path leakage: Check the following: Whether the
hydrogen outlet pipe is leaking; whether the hydrogen outlet pipe is broken or
blocked; whether the liquid level is below the minimum limit; or if there is an
obvious air leak. Contact Promolife for instructions.
Display does not light up/low hydrogen fl ow: Check to make sure the power
cord is properly connected at both the machine and the outlet. If it is, contact
Promolife for assistance.
If you have any other issues: Feel free to contact Promolife for more specifi c
troubleshooting.
Note: When the machine is not
used for a long time, fi ll it with
water and start it at least once
a month for 30 minutes each
time.
Water Inlet
Stop/Start
Reset
Time Input
Display
Water Level Indicator
H2 O2
Heat Sink
Vent Drain
Power
On/Off
Water Inlet
DRAINING/CLEANING INSTRUCTIONS
1. If you don’t plan to use the machine often or simply need to replace the water,
you will need to drain the unit. Prepare a container to drain the water into.
2. Insert the drain pipe into the drain until you hear a click. The water will
automatically drain from the drain pipe.
3. Use a clean towel to wipe the surface. Do not use volatile chemical solvents to
clean.
A diagram of the control panel and its functions can be found on the next page.