Name
No.
Type
Description
Start-Stop
2
BYTE
Corresponds to Start-Stop switch; if Start-Stop = 0, then the pump is
stopped.
Reset
3
BYTE
If the “Reset” value is switched from 1 to 0, the internal pump memory
is deleted (e.g. with batch metering) and - as far as possible - pending
errors are cleared.
Mode
4, 5
BYTE
Value
Name
Description
0
Halt
Pump is ready but not metering.
1
Manual
Pump is metering continuously at
the set frequency.
2
Batch
When triggered, the pump meters
the number of revolutions set in
batch pre-selection.
3
Contact
Pump meters the number of revo‐
lutions calculated from the product
of "Number of triggers * External
factor".
4
Analog
Pump meters according to the ana‐
logue signal and the
‘Analog’
operating mode set on the pump.
Dosing rate
6, 7
UINT16
Dosing rate set in litres / hour ("Minimum" .. "Maximum dosing rate").
Actual dosing rate
8
UINT16
Actual dosing rate in litres / hour (0.. "Maximum dosing rate").
Maximum dosing
rate
9
UINT16
Maximum dosing rate in litres / hour
Batch pre-selection 10, 11
UINT32
Number of half revolutions in batch mode per trigger. (12 … Maximum
= 999.999 litres / trigger).
Batch start
12
BYTE
If the value changes from 1 to 0, batch metering is activated in batch
operation. Batches can also be activated via the contact input.
Batch memory
13
BYTE
If the batch memory is activated and a new batch is triggered during
batch metering already in progress, then the remaining revolutions are
increased by the number of the new batch.
If the memory is not activated, the remaining revolutions of the batch
not yet processed are cleared and the new batch is processed.
Remaining revolu‐
tions
14
UINT32
The remaining revolutions still to be processed with batch metering
External factor
15, 16
UINT16
Factor by which the incoming pulses are multiplied. The factor is given
as a hundredth. Value range is 2…19998 - the factor is then 0.01…
99.99 revolutions.
External memory
17
BYTE
As with batch metering, once again here high factors are added
together or the remaining revolutions are cleared.
Direction of rotation 19
UINT16
Target direction of rotation 0 = clockwise and 1 = counter-clockwise
Hose service life
20
UINT32
Hose service life - revolutions since the last hose change
Error
21
UINT16
bit
Name
Function
0
Minimum
Metering liquid level too low
1
Batch
Too many revolutions > 100000
2
Analog < 4mA
Analogue current is less than 4 mA
3
Analog > 23mA Analogue current is greater than 23
mA
4
Temperature
error
Temperature too high
5
Hose rupture
Metering hose damaged
Operation
10
