8
ASSEMBLY INSTRUCTIONS
9. Tighten the secondary support screw securing the
braided cable.
9
Secondary Support Screw
Blade Screw
Blade Washer
Blade Arm
Blade
Canopy
Mounting Bracket Screw
J-shaped Slot
Round Hole
Black (Hot)
White (Neutral)
Bare/Green (Ground)
Green
Black
White
11. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy in a clockwise direction until the
mounting bracket screws are completely engaged in
the J-shaped slots. Install the two previously removed
mounting bracket screws in the round holes. Securely
tighten all mounting bracket screws.
12. Partially insert three blade screws along with blade
washers through the blade and into the blade arm.
Tighten each blade screw with a Phillips screwdriver (not
included) starting with the one in the middle. Repeat this
step for the remaining blades.
10. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black from the fan to the black (hot) supply
wire.
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire.
Important:
After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
11
12
10
Wire Connector
Summary of Contents for 51676
Page 1: ......