1/4-20 Threaded Mounting Adapter
3/8-16 Threaded Mounting Adapter
#A14 Anti-Rotation Holes
(not included)
1/4-20 Threaded Mounting Adapter
#HM1,
Bottom View
Safety Stop Screw
Optional Configuration
Do you wish to use the #HM1 Head with an Arca Compatible Plate on your camera
rather than your lens plate? The #C60 Top Clamp can be rotated 90° to allow just that
configuration. Hardware was included to remove the #C60, adjust the anti-rotation
pins, rotate the clamp and reinstall.
Using the supplied
5/32
Allen Key, remove the screw holding the #C60 to the #HM1.
Carefully remove and store the (2) non threaded dowel pins located in the clamp.
Next, using the small supplied
1/16
Allen Key insert the (2) small anti-rotation set
screws. The screws should stick above the #C60 Clamp approximately 1/4 inch.
Finally, rotate the #C60 clamp 90° and install back onto the #HM1. You may select
to have the clamp face forward or backwards to fit your shooting style. Reinstall the
large center screw onto the clamp. Verify the connection is snug and the clamp is
flush to the #HM1 body before shooting.
1.
2.
3.
4.
Safety Stop Screw
