Promax MD-200B, Manual

Page: 51 / 78

USER’S MANUAL. MD-200B
03/2006
Page 19
En
g
lis
h
4 MAINTENANCE
4.1
Battery installation or replacement
Meter is powered through the mains or 6 piece of 1.5V battery. Refer to Figure
3 and use the following procedure to replace the battery:
1. Disconnect test leads from any circuit under test, turn the ON/OFF switch on the
rear panel to off and remove the test leads from the meter.
2. Open the accessory compartment by pressing back and up on the button.
Remove any stored accessories.
Opened by screwdriver
Opened by coin
Battery connector
Battery box
Battery (1.5Vx 6)
Button
Battery cover
Figure 3.- Battery replacement
3. Using a slot-head screwdriver, key, or other appropriate tool, pry open the top of
the battery cover and lift the cover out.
ATTENTION
:
Use only 1.5 V LR6 type batteries.
4. Disconnect the battery connector leads and remove the battery from the battery
box.
5. Replace the new battery to battery box and snap the battery connector leads to
the terminals on battery box.
6. Reinsert the battery convert in the multimeter.